Rahul's RC Aircraft and other designs

A 1m  Thermal flying wing - Plank Dimensions and details :-             Electronics       a.        Motor = 2206 200KV b.        Prop = 7x4 folding c.        Bty = 2S  750/1000 mah d.        ESC = 30A 8.        AUW = 310g,  Wing area = 220000 sq mm, Wing Loading - 4.65 oz/sq ft, Wing cubic loading - 3 The wing is hotwired from EPS (Thermocole). It has a built-up 10mm CF tow spar  and skinned with 32 gsm fiberglass at 45 degree  bias. the wing tips are EPP . The fuselage is only in the front portion to house the ESC, RX, Motor and battery.. The vertical tail is stuck on a 3 mm CF rod and glued to the wing TE. The elevon is 3mm balsa sanded to a thin TE. The elevon is bottom hinged In the final version, the servos were moved inwards and positioned at the...

A "plank" flying wing  Details 1. Span 60" 2. Root Cord : 11.5", Tip Cord : 7.5" 3. Airfoil : PW 106 4. AUW : 605 g It is a "plank" flying wing, with very moderate taper. The wing is "hotwired" out of EPS a.k.a "thermocole". It has a 1.5 mm X 3.0 mm CF strips glued on the top and bottom surface of the wing to act as spar. The whole thing acts as a beam, and with the CF under tension becomes very stiff.. and is very light weight.  In the past I used to cover the foam with paper. This time, it has been covered with monokote, ironed-on. With some testing, the suitable temp was found which stuck & shrunk the film without damaging the foam. The wing covered with monokote, came out very good. The elevon is a constant cord elevon @ 10 % of wing area some pics The hot wired cores The reinforced roots with the joiner tubes. Had to use some polyurethane glue to harden the grooves, and fiber tape to reinforce the whole a...